Please see the following steps of how to install the water tank.
5.Install the tie rod inside the tank
In 5meter length direction, Screw the rods to the tank panels by bolts and nuts in the two sides of 5 meter.
In 4 meter length direction, Screw the rods to the tank panels by bolts and nuts in the two sides of 4meter.
Tie rod qty:
Î¦16Ã—5mÂ :21 pcs
Î¦16Ã—4m: 28 pcs
6. Support Bar: Put the support bar between the join of panel vertically to
support the cover panel . It will prevent the cover hang down .
As shownÂ in following : top view of 5mÃ—4m side
Support bar qty: 2m length: 6pcs
7. Install the plugging: There is one leaking stoppage in the 45Â°cornerwhich be fastened by screw with seal strip and silicon sealant . As shownfollowing :
PluggingÂ details: The surface where connected with the panel should be sealed by sealÂ strip , Glass glue is used in the plugging position.
Plugging qty: 18pcsÂ Â Â glass glue qty: 2 packages
8. Ladder Installation : Fix the ladder on the fixed clip by boltand nuts .
Ladder qty: 2m&2.5m
Ladder clip qty: 4 pcs
9. Install the Water level indicator.
10. Clean : After installation , clean it up .
11. Test : Injectingwater till full , it will be standard if no leakage for 24hours .
If you are interested in our water tank, please contact us at any time. Email: firstname.lastname@example.org