Zaoqiang Langtai water storage tank tell you how to install the water tankï¼ŒPlease see the following stepsï¼š
1. Install the water tank bottom plates.
Put the sealing rubber stripÂ between the two tank plates. Please remember put theÎ¦10 washer in the bolts and plates when screw the bolts in the plates. Fasten screws twice to four times, donâ€™t fasten too hard at a time to avoid breakage. When finishing the installation of the bottom plates, please fix it on the C-channel steel frame with screw bolts.
2. Install the sideâ€™s plates.
According to the marks on the plates, separateÂ the plates. Firstly screw the bolts and nuts to join the Side 1stÂ plates. And then screw the bolts and nuts to join the Side 2ndÂ plates. Please look at the CD. (We will supply you CD video)Â when screwing the bolts and nuts, please add Fasten anglesÂ which the size is 930mm one side without the washer, on the other side near to the bolts need to add the Î¦10 washer.
3. Install the inside drawing bars and outside drawing bar plates.
4. Install the Pressure Seal in 4 corners.
5. Install the top roof plates, inner support brace, inner and outside ladders.
6. Install the flanges(inlet pipe, outlet pipe, other 2pcs for reserve), and connect them with water valves.
7. Please pay more attention on screwing the bolts and nuts. Make sure toÂ fastenÂ the bolts one by one continuously, please do not fasten one bolt only to avoid tank platesâ€™Â damage.
Â Â Â Â Seal the gap with silicone sealant if need.
8. After installation are finished, make unified examination, to make sure no leakage.